På min C70 så går det att stänga och öppna rutorna med fjärren,
även stänga och öppna taket och starta motorn med fjärren plus lite mera.
SmartTop heter lösningen.
Detailed function description (* = Factory setting)
Function 1 - Product Enable - Workshop/Diagnose Mode ( 0=OFF / *1=ON / 2=NO HAZARDS )
When disabled, the module becomes completely inactive and behaves as if it was not installed. This is useful if you
need to take the car to the dealer or garage for inspection or repairs. The module can not even be seen by and
does not interfere with the dealer's workshop tester.
Setting 2 disables blinking of the hazards during remote operation.
Function 2 - One-Touch for the soft-top switch ( 0=OFF / *1=ON / 2=EXTENDED[!] )
When enabled, the center console switch operation is enhanced as follows:
Holding down the switch in either direction will operate the top as long as the switch is held.
A short tap on "OPEN" will open the top completely.
A short tap on "CLOSE" will close the top completely.
Tap in the opposite direction at any time for emergency stop.
When set to EXTENDED mode, it is possible to turn the ignition off and pull the key out, while the top operation
continues. [!] USE WITH EXTRA CAUTION!
Function 3 - Remote Control ( 0=OFF / *1=ON / 2=EXTENDED[!] )
This function allows top operation with the original remote fob by tapping the "OPEN" or "CLOSE" button on the
remote. Once started, the top will complete the cycle automatically. Tapping any button on the remote will interrupt the
operation immediately.
While the top in in motion, the hazard lights flash as a warning signal (unless disabled by function 1).
Full overview of all modes of remote operation:
Hold down UNLOCK on the remote to open all windows (factory feature).
Tap LOCK on the remote twice to close all windows.
Tap UNLOCK on the remote 3x (in 1 sec intervals) to open the top.
Tap LOCK on the remote 3x (in 1 sec intervals) to close the top.
When set to EXTENDED mode, it is possible to turn the ignition on and start the engine or lock the doors with the
remote, while the top operation continues. [!] USE WITH EXTRA CAUTION!
Function 4 - Maximum allowed speed for top operation ( *0=0kmh / 1=10kmh / 2=20kmh / 3=30kmh / 4=40kmh )
Setting the max allowed speed for top operation in steps of 10km/h (~7mph). Setting 0 only allows top operation while
halted.
Function 5 - All-Windows-Switch ( *0=NORMAL / 1=ONE-TOUCH )
This function allows to program the driver's door "all-windows" switch to raise all windows using One-Touch. By
factory this switch only does One-Touch down.
Function 6 - Automatic door unlocking ( *0=OFF / 1=ACC / 2=IGN )
This function can be set to automatically unlock the doors when either the key is pulled from the ignition lock (setting
ACC) or when the ignition is turned off (setting IGN). This removes the requirement to pull the door handles twice to
get out of the car.
Function 7 - Passenger mirror park assist ( *0=OFF / 1=ON )
Requires Seat memory. When enabled, the passenger side mirror will dip down upon shifting to reverse gear. After
leaving reverse gear, the mirror will return back up if one of these conditions is met: a) 10 sec. inactivity or b) forward
speed of >5mph is detected.
The module switches between memory positions 1 (driving) and 3 (backing up), so to program the desired backing up
mirror position, simply save it's position in memory no. 3
Här har jag köpt min:
http://www.aftermarketbulbsshop.com/sma ... thfvo1.htm
//Mike
-)
- By rd350
- By ShogunX