[danielfredriksson]

Skulle behöva veta med vilket moment som man ska dra åt ramlagrena i en Volvo T6 motor.

Hoppas ni förstår vad jag menar.

MVH daniel

[TerSve]

Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft.
Lift in these and the front of the crankshaft.
Carefully position the crankshaft in the block.
The crankshaft must not be turned before the intermediate section has been torque tightened.
Position the intermediate section.
Lubricate and install all the screws.
Install the intermediate section and the screws on the exhaust side at bearing recesses 2 and 6.
Pull the intermediate section down against the cylinder block.
Caution! The M8 screws on the exhaust side are two different lengths.
Note! Use new M10–screws.
Tighten the screws in the following order:
1. All M10 screws........20 Nm
2. All M10 screws........45 Nm
3. All M8 screws........24 Nm
4. All M7 screws........17 Nm
5. Angle-tighten all M10 screws........90°

Tighten the screws in sequence from the centre and outwards.

Kan detta hjälpa?

[danielfredriksson]

Ja det hjälpte jättemycket :D tack med stora bokstäver!