S60 2.4t går dåligt plus felkoder
Postat: fre 30 jul 2010, 18:42
av kungola
Har en s60 2.4t -01 som går dåligt när man skall köra iväg, hostar sig framåt. Läste av bilen med en felkodsavläsare och den lämnade felkoderna ECM-1600 laddtrycksgivare och ECM-170F Atomsfärtryckgivare/laddtrycksgivare rimlighetskontroll. Vad beror dessa felkoder på och vad skall jag söka efter? Har kollat slangarna men dom verkar vara hela, finns det något annat?
Re: S60 2.4t går dåligt plus felkoder
Postat: fre 30 jul 2010, 20:36
av andreas 80
Saxat från Vadis
ECM-1600
Condition
If the control module receives a signal from the boost pressure sensor which is lower than 0.2 V (low signal) or higher than 4.85 V (high signal) it is interpreted as a fault and ECM-1600 is stored.
Substitute value
Boost pressure control runs in an open-loop, in other words set duty cycles are generated regardless of boost pressure.
Possible source
Signal too high:
-contact resistance in terminals
-short-circuit to supply voltage in the signal cable
-open-circuit in signal cable
-defective boost pressure sensor
Signal too low:
-short-circuit to ground in the signal cable
-defective boost pressure sensor
Fault symptom[s]
-none
ECM-170F
Condition
Diagnostic trouble code (DTC) ECM-170F is stored if the boost pressure sensor's registered pressure deviates from the atmospheric pressure sensor's registered pressure. This comparison is made at engine start (at approximately 500 rpm) before the turbocharger (TC) has built up a boost pressure.
Substitute value
Possible source
Faulty signal
-contact resistance in terminals
-defective boost pressure sensor
-defective atmospheric pressure sensor
Fault symptom[s]
-none
Så eftersom du har båda dessa felkoder så pekar mycket åt att din laddtryckgivare inte fungerar som den skall, antingen dålig kontakt eller så behöver den troligtvis bytas ut.